1072, ODR Rheometers

Standard ASTM D-2084
ISO-3417
Frame Weight 195 lb
89 kg
Frame Depth 25 in
63.5 cm
Frame Width 21 in
53.5 cm
Frame Height 42 in
107 cm
Temperature Controllers P.I.D.
Temperature Range 100 to 400 ºF
35 to 205 ºC
Accuracy ± 0.5 ºF
0.2 ºC
Motor Speed 100 rpm
Maximum Torque 200 in·lb
22.6 N·m
Degree of Arc 1
3
5
Motor Voltage1 115 V
Motor Frequency 60 Hz
Phase2 1
Pneumatics Pressure 90 psi
620 MPa
Pneumatics Volume 2 ft³/min
0.06 m³/min
Computer System

500 MHz CPU, 10GB HDD, 64 MB RAM, 48X CD ROM
IBM-compatible PC
SVGA color monitor

Software
  • Cure-test program per ASTM D-2084 and ISO-3417
  • Library storage of data by compound
  • Package includes mean, std. deviation and coef. of variation, with max. min. and histogram
  • Data can be exported to popular spreadsheets and statistical programs
  • Windows 95, 98, NT, 2000, ME and XP compatible program
ODR Test Software

All-aluminum test frame is rugged, yet light-weight. An anti-tiedown control switches prevent operator injury.

P.I.D. temperature controllers, temperature probes and cast-in platen heaters insure rapid heat-up and stable, constant temperature to the test sample.

Thermo isolators separate electronic and mechanical components from heat, providing more-consistent test results and less potential for mechanical failure.


1 Other systems available.
2 Other systems available.

This oscillating disk-cure rheometer, per ASTM D-2084 and ISO-3417, tests elastomeric materials to determine values for viscosity, cure characteristics and temperature at various points in the cure cycle.

Computerized testing simplifies and reduces setup, data acquisition and display time.

The ODR software prompts the user through each screen, which greatly reduces employee training time. This software builds your data library by compound, batch and test, and stores data, on hard drive or disks, for future analysis.

The cure curve is displayed on monitor during test and can be printed after test or recalled and displayed on the screen at a later date.

Gate parameters can be set for all data points; any point out of parameter is flagged during test and marked on the test report.

This report includes cure curve and torque/time data for all selected points.

Statistical analysis is done on all selected data points.